Siemens S7-300 - 7 Programming the FM 352

FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
39
Programming the FM 352
7
If your CPU supports the system blocks SFB 52 and SFB 53 with DPV1 functionality
Then use the blocks from the program folder "FM 352 CAM V2" to program the FM 352.
In addition to centralized use in the S7-300, these blocks also support distributed use with
PROFINET and PROFIBUS DP.
You will find a description in this section.
If your CPU does not support the system blocks SFB 52 and SFB 53 with DPV1 functionality
Then use the blocks from the program folder "FM 352,452 CAM V1" to program the FM 352.
For a description, please refer to Appendix D "Programming without SFB 52 and SFB 53
(Page 199)".