Siemens S7-300 - 4 Addressing and installation; 4.1 Address Assignments in the CPU

Wiring the FM 352
5.3 Connecting the encoder
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
31
5.3 Connecting the encoder
Shield connection element
The shield connection element is a comfortable means of bonding all shielded cables to
ground, due to the direct connection between the shield connection element and the rack.
You will find detailed information in the Operating Instructions SIMATIC S7-300 CPU 31xC
and CPU 31x: Installation (http://support.automation.siemens.com/WW/view/en/13008499
).
Procedure
1. Wire the cable to the encoder.
The cables of absolute value encoders may have to be prepared (cable end to encoder)
according to the manufacturer specifications.
2. Open the front panel cover and insert the d-sub connector into the FM 352.
3. Secure the connector by tightening the finger screws. Close the front cover.
4. Strip the cable, then clamp the shielding into the shield connection element. Use shield
connection terminals.