Data blocks / error lists
C.1 Content of the channel DB
FM 352 electronic cam controller
178 Operating Instructions, 05/2011, A5E01071724-03
Address Name Type Initial value Comment
25.0 SYNC BOOL FALSE 1 = axis is synchronized
25.1 MSR_DONE BOOL FALSE 1 = length measurement or edge detection
completed
25.2 GO_M BOOL FALSE 1 = axis moving in negative direction
25.3 GO_P BOOL FALSE 1 = axis moving in positive direction
25.4 HYS BOOL FALSE 1 = axis within the hysteresis range
25.5 FVAL_DONE BOOL FALSE 1 = set actual value on-the-fly executed
26.0 ACT_POS DINT L#0 Current position of axis
30.0 TRACK_OUT DWORD DW#16#0 Current signals of tracks 0 to 31
Bit 0 = track 0
Function switches
34.0 EDGE_ON BOOL FALSE 1 = edge detection on
34.1 SIM_ON BOOL FALSE 1 = simulation on
34.2 MSR_ON BOOL FALSE 1 = length measurement on
34.3 REFTR_ON BOOL FALSE 1 = retrigger reference point
34.4 SSW_OFF BOOL FALSE 1 = software limit switch deactivated
Trigger bits for write jobs
35.0 MDWR_EN BOOL FALSE 1 = write machine data
35.1 MD_EN BOOL FALSE 1 = enable machine data
35.2 AVALREM_EN BOOL FALSE 1 = set actual value, cancel set actual value
on-the-fly
35.3 CAM1WR_EN BOOL FALSE 1 = write cam data 1
(cams 0 to 15)
35.4 CAM2WR_EN BOOL FALSE 1 = write cam data 2
(cams 16 to 31)
35.5 CAM3WR_EN BOOL FALSE 1 = write cam data 3
(cams 32 to 47)
35.6 CAM4WR_EN BOOL FALSE 1 = write cam data 4
(cams 48 to 63)
35.7 CAM5WR_EN BOOL FALSE 1 = write cam data 5
(cams 64 to 79)
To Next Page
Loading...
