Siemens Simantic ET 200S - TE-U120 S4 X10 and TE-U120 C4 X10 Supplementary Terminal (6 ES7193-4 Flx0-0 AA0); Table 1-1 Potential Groups on the Supplementary Terminal

Terminal modules
1.14 TE-U120S4x10 and TE-U120C4x10 supplementary terminal (6ES7193-4FLx0-0AA0)
ET 200S
Manual, Edition 10/2005, A5E00514527-01
1-19
1.14 1.14 TE-U120S4x10 and TE-U120C4x10 supplementary terminal
(6ES7193-4FLx0-0AA0)
Properties
• 40-pin extension for
– the TM-C terminal module for COMPACT modules
– any terminal modules with a width of 120 mm
• available in two variants: screw terminal, spring terminal
• Any additionally required potentials can be applied to the supplementary terminal, e.g.
with 3 or 4-wire connection of sensors or actuators.
• The four potential groups on the supplementary terminal can be adapted (extended) for
the local requirements with pluggable bridges.
Extending the potential groups
The supplementary terminal is fitted with three pluggable bridges on delivery.
If it is necessary to apply more than one potential to the supplementary terminal, the
potential groups on the supplementary terminal can be extended. This is done with
pluggable bridges that connect two or more groups. After removal of corresponding bridges
terminals are available for additional potentials.
Table 1-1 Potential groups on the supplementary terminal
Quantity
inserted
bridges
Potential
groups
Position on the supplementary terminal
3
1
1
-XPSHULQVHUWHG
2 2