Analog electronic modules
4.22 2AO I High Feature analog electronic module (6ES7135-4MB02-0AB0)
ET 200S
4-106 Manual, Edition 10/2005, A5E00514527-01
Suppression of interference, limits of error
Crosstalk between the outputs min. -40 dB
Operational limit (in the entire temperature
range, with reference to the output range)
± 0.5 %
Basic error limit (operational limit at 25 °C
with reference to output range)
± 0.3 %
Temperature error (with reference to the
output range)
± 0.01 %/K
Linearity error (with reference to the output
range)
± 0.02 %
Repeatability
(in steady state at 25 °C with reference to
output range)
± 0.05 %
Output ripple (with reference to output range,
bandwidth 0 to 50 kHz)
± 0.02 %
Data for selecting an actuator
Output range (rated value) ± 20 mA
4 to 20 mA
Load resistance max. 500 Ω
• For inductive load
1 mH
• Open circuit voltage
18 V
Destruction limit against voltages/currents
applied from outside
• Voltage at the outputs to M
ANA
15 V continuous; 75 V for max. 1 ms
(sampling ratio 1:20)
• Current
max. 50 mA DC
Connection of actuators
• Two-wire connection
Yes
• Four-wire connection
no
4.22 4.22 2AO I High Feature analog electronic module
(6ES7135-4MB02-0AB0)
Properties
• 2 outputs for current output
• Output range:
– ± 20 mA, resolution 15 bits + sign
– 4 to 20 mA, resolution 15 bits
• Isolated from the load voltage L+
• Supports isochronous operation
– Minimum time for the synchronous DP cycle (T
DPmin
): 3.75 ms
– Minimum conversion time of the output modules: (T
WAmin
): 1.5 ms
To Next Page
Loading...
