Digital electronic modules
3.14 2DO 24 VDC/0.5 A High Feature digital electronic module (6ES7132-4BB01-0AB0)
ET 200S
3-56 Manual, Edition 10/2005, A5E00514527-01
3.14 3.14 2DO 24 VDC/0.5 A High Feature digital electronic module
(6ES7132-4BB01-0AB0)
Properties
• Digital electronic module with two outputs
• Output current 0.5 A per output
• Rated load voltage 24 VDC
• Diagnostics: Wire break
• Diagnostics: Short circuit
• Short-circuit protection
• Suitable for solenoid valves, DC contactors, and indicator lights
• Supports isochronous operation
Peculiarity
When you connect the 24 VDC rated load voltage to the power module by means of a
mechanical contact, depending on the circuit the digital outputs carry the "1" signal for
approximately 50 µs. You need to take this into account if you connect the module to fast
counters.
General terminal assignment
Note
Terminals 4, 8, A4, A8, A3 and A7 are only available at specified terminal modules.
Terminal assignment for 2DO 24 VDC/0.5 A High Feature (6ES7132-4BB01-0AA0)
Terminal Assignment Terminal Assignment Notes
1 DO
0
5 DO
1
2 L+ 6 L+
3 M 7 M
4 n.c. 8 n.c.
A4 AUX1 A8 AUX1
A3 AUX1 A7 AUX1
• DO
n
: Output signal, channel n
• L+: Rated load voltage 24 VDC
• M: Ground
• n.c.: Not connected (max. 30 VDC can be connected)
• AUX1: Protective-conductor terminal or potential bus (freely usable
up to 230 VAC)
To Next Page
Loading...
