Siemens SIMATIC ET 200SP Function Manual

Open User Communication
6.5 Setting up Open User Communication via TCP, ISO-on-TCP, UDP and ISO
Communication
76 Function Manual, 11/2019, A5E03735815-AH
3. Select the "Connection parameters" group. Until you select a connection partner, only the
empty drop-down list for the partner end point is enabled. All other input options are
disabled.
The connection parameters already known are displayed:
– Name of the local end point
– Interface of the local end point
– IPv4 address of the local end point
Figure 6-4 Connection parameters for TSEND_C

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C