Siemens SIMATIC ET 200SP Function Manual

Open User Communication
6.5 Setting up Open User Communication via TCP, ISO-on-TCP, UDP and ISO
Communication
Function Manual, 11/2019, A5E03735815-AH
77
4. In the drop-down list box of the partner end point, select a connection partner. You can
select an unspecified device or a CPU in the project as the communication partner.
Certain connection parameters are then entered automatically.
The following parameters are set:
– Name of the partner end point
– Interface of the partner end point
– IPv4 address of the partner end point
If the connection partners are networked, the name of the subnet is displayed.
5. In the "Configuration type" drop-down list, select between using program blocks or
configured connections.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C