Siemens SIMATIC ET 200SP Operating Instructions

1.4 Open Source Software
Open-source software is used in the firmware of the product described. Open Source Software
is provided free of charge. We are liable for the product described, including the open-source
software contained in it, pursuant to the conditions applicable to the product. Siemens accepts
no liability for the use of the open source software over and above the intended program
sequence, or for any faults caused by modifications to the software.
For legal reasons, we are obliged to publish the original text of the license conditions and
copyright notices. Please read the information on this on the Internet (https://
support.industry.siemens.com/cs/ww/en/view/109740777).
The license terms are stored on the device and available via the web server. For more on this,
refer to section Calling the web server (Page 50). To view the license conditions, click the
"OSS ReadMe" button.
To resellers: Pass the license conditions on to the buyer to avoid license violations by the
reseller and the buyer.
Introduction
1.4 Open Source Software
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 13

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C