Siemens SIMATIC ET 200SP Operating Instructions

6. Write DR03 by entering the command code 4003 for the "code" parameter in the
"Command1" command mailbox.
7. Set the associated command trigger "trigger" to "true".
8. Evaluate the associated status bits:
Command finished without error. [finishedOk] is "true".
⇒ The new calibration weight is now present in the electronic weighing system and is used.
9. Disable service mode by entering command code 2 for the "code" parameter.
10.Set the associated command trigger "trigger" to "true".
6.2.4 Cyclic data exchange via "cyclicIoData"
The interface DB of the FB makes the "cyclicIoData" structure available. All parameters in this
structure are updated cyclically by the electronic weighing system to the SIMATIC controller. All
entered parameter values within the "cyclicIoData" structure are used directly – without reading
or writing DRs.
The following parameters are available for use within the "cyclicIoData" structure on the factory
side:
Parameter assignment/addressing
6.2 TIA Portal user program
Technology module TM SIWAREX WP351 HF
46 Operating Instructions, 01/2020, A5E47521010-AA

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C