Siemens SIMATIC ET 200SP Operating Instructions

6.15 DR20 Configuration of set point [setPoint]
Introduction
The set point in "CW - Automatic check weigher" defines the reference weight of an individual
dosing to be checked with the defined weight unit (Page 59).
Procedure
1. Enter the set point [setPoint] in DR20.
The set point is smaller than the maximum permissible set point (Page 98) from DR25.
2. Write DR20.
6.16 DR21 Configuration of total set point [totalSetPoint]
6.16.1 DR21 Configuration of total set point in DTI
Introduction
The total set point in "DTI - Discontinuous totalizing automatic weighing instruments" specifies
the total weight to be loaded with the defined weight unit (Page 59).
Material in feed intake (pre-signal) [materialDisposed]
Specifies the material weight in the feed intake to the scale with the defined weight unit.
Maximum allowed total set point undercut [maxTotalSetPointDeviation]
Defines the maximum permissible underrun of the total weight to be loaded with the defined
weight unit.
Requirement
You have selected the weighing operating mode DTI Discontinuous totalizing automatic
weighing instrument (Page 57).
Parameter assignment/addressing
6.16 DR21 Configuration of total set point [totalSetPoint]
Technology module TM SIWAREX WP351 HF
86 Operating Instructions, 01/2020, A5E47521010-AA

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C