Siemens SIMATIC ET 200SP Operating Instructions

9. Place the unlock protection on the BaseUnit in such a way that the top end of the unlock
protection is placed in the housing of the electronic weighing system.



① Top end for inserting in the electronic weighing system
② Recesses for the fastening screws
③ Cable routing
Figure 7-1 Secure the unlock protection
10.Secure the unlock protection with three fastening screws.
The electronic weighing system can no longer be removed from the BaseUnit.
The connecting cables of the electronic weighing system, load cells or terminal boxes can
no longer be removed.
7.2 Checking parameters relevant to the calibration
Introduction
Verification of the scale according to Modul F of the corresponding directive by the conformity
assessment table involves the following procedure.
Operation requiring official calibration
7.2 Checking parameters relevant to the calibration
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 125

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C