Siemens SIMATIC ET 200SP Operating Instructions

Parameter Add info [errorAddInfo]
Filter 2 period (s) 375
Characteristic low pass filter 376
Ordinal number low pass filter 377
Cut-off frequency low pass filter 378
Operating mode 380
Totalization scale interval dt 381
Minimum totalized load 382
SecureDisplay interface 383
Stringheader FW-Version SecureDisplay 384
Version SecureDisplay 385
Smallest zoom factor of SecureDisplay (%) 386
Period of dosing filter 388
9.4.5 Add info [errorAddInfo] for DR05 and DR06
Table 9-4 Add info [errorAddInfo] for DR05 and DR06
Parameter Add info [errorAddInfo]
Current preset-tare weight 501
Current semi-automatic tare weight 502
Current initial zero-setting weight 504
Current semi-automatic zero-setting weight 505
Current zero tracking weight 506
Dead load (calculated) 507
Reference (limits 1 and 2) 601
Limit 1 ON value 603
Limit 1 OFF value 605
Limit 2 ON value 607
Limit 2 OFF value 609
Reference (limit 3 - empty) 611
Limit 3 - empty 613
Switch-on delay limit 3 (empty) (s) 614
9.4.6 Add info [errorAddInfo] for DR07
Table 9-5 Add info [errorAddInfo] for DR07
Parameter Add info [errorAddInfo]
Assignment digital input DI.0 701
Assignment digital input DI.1 702
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 139

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C