Siemens SIMATIC ET 200SP Operating Instructions

Data and command errors Error code
[errorCode]
Add info
[errorAd‐
dInfo]
Description
9510 Service mode not active
9530 Weight is outside the permissible tare weight range
9531 Weight is outside the permissible zero setting range
7055 Parameter error DR06 7055 Additional information indicates an implausible parameter in DR06
Parame‐
ter ID
Parameter ID of the affected parameter in DR06
7056 Parameter error DR07 7056 Additional information indicates an implausible parameter in DR07
Parame‐
ter ID
Parameter ID of the affected parameter in DR07
9650 DQ.0 - assignment not possible
9651 DQ.1 - assignment not possible
9652 DQ.2 - assignment not possible
9653 DQ.3 - assignment not possible
7057 Parameter error DR48 7057 Additional information indicates an implausible parameter in DR48
Parame‐
ter ID
Parameter ID of the affected parameter in DR48
7058 Parameter error in
DR11
7058 Additional information indicates an implausible parameter in DR11
Parame‐
ter ID
Parameter ID of the affected parameter in DR11
9510 Service mode not active
7060 Error in extended pa‐
rameters DR 15 - DR 19
7060 Additional information indicates an implausible parameter in DR 15
- DR 19
Parame‐
ter ID
Parameter ID of the affected parameter in DR 15-19
9530 , because weight is outside the permissible tare weight range
7061 Error set point DR 20
or DR 21
7061 Additional information indicates an implausible parameter in DR20/
DR21
Parame‐
ter ID
Parameter ID of the affected parameter in DR 20/DR 21
7062 Error in dosing system
parameters DR 22/DR 23
7062 Additional information indicates an implausible parameter in DR22/
DR23
Parame‐
ter ID
Parameter ID of the affected parameter in DR 22/DR 23
9071 Parameter relation not plausible
5914 Fine flow, coarse/fine dribbling and set point are incompatible
9191 Fine flow is less than the coarse dribbling value
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
136 Operating Instructions, 01/2020, A5E47521010-AA

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C