EasyManuals Logo

Siemens SIMATIC ET 200SP Operating Instructions

Siemens SIMATIC ET 200SP
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
Requirements
Automatic calibration requires the following criteria:
Correct mechanical installation of the scale without shunt forces
Scale is empty (only mechanical installation (= dead load) present on the cells)
Installed load cells are evenly loaded
Procedure
1. During the first commissioning, reset using the electronic weighing system with the
command "Load factory settings (11)" or "Load standard parameter (12)".
2. Select the "Service mode ON (1)" command.
3. Read DR10.
4. Specify the load cell parameters in DR10 (Page 78).
5. Write DR10.
6. Select the "Service mode OFF (2)" command.
7. Start the "Automatic calibration (82)" command.
Result
The characteristic curve of the scale is calculated using the specified load cell parameters from
DR10 and the currently applied dead load. The characteristic curve is active immediately.
The characteristic data from DR03 is overwritten with the command "Automatic calibration
(82)".
Commissioning
5.2 Automatic calibration
Technology module TM SIWAREX WP351 HF
36 Operating Instructions, 01/2020, A5E47521010-AA

Table of Contents

Other manuals for Siemens SIMATIC ET 200SP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC ET 200SP and is the answer not in the manual?

Siemens SIMATIC ET 200SP Specifications

General IconGeneral
System TypeDistributed I/O System
MountingDIN Rail
Communication ProtocolPROFINET, PROFIBUS
IP RatingIP20
CategoryI/O Systems
Supply Voltage24 V DC
ModularityYes
Hot SwappingYes
Storage Temperature-40°C to +70°C
Digital InputsYes
Digital OutputsYes
Analog InputsYes
Analog OutputsYes
Communication InterfacePROFINET, PROFIBUS
Number of ModulesUp to 64
Relative Humidity5 to 95% (non-condensing)
Operating Temperature-25°C to +60°C

Related product manuals