Siemens SIMATIC ET 200SP Operating Instructions

4. Assign the interface DB to the electronic weighing system for the parameter interface
"Interface".
HW_ID HW ID of the electronic weighing system
Interface Interface DB of the electronic weighing system
ERROR "true" = Error
RET_VAL The meaning of the error codes can be found in the section: Operating errors
(Page 130).
LIFEBIT Optional status bit can be used to monitor communication
Figure 6-2 FB
5. Copy the HMI or the required components from the example project into the destination
project.
Parameter assignment/addressing
6.2 TIA Portal user program
Technology module TM SIWAREX WP351 HF
42 Operating Instructions, 01/2020, A5E47521010-AA

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C