Commissioning
7.6 Selecting connection alternatives
SIMATIC MV500
142 Operating Instructions, 03/2021, C79000-G8976-C494-05
Setting the IP address for "X2 LAN2"
Note that you can only set the IP address for the "X2 LAN2" interface via the WBM.
Ethernet interfaces in different subnets
Note that you must operate the Ethernet interfaces "X1 LAN1" and "X2 LAN2" in two
different subnets. If you do not comply, you cannot save the changes in the WBM, or if you
use SINEC PNI, the IP address of the "X2 LAN2" interface is discarded.
To Next Page
Loading...
