Siemens SIMATIC MV500 - Page 212

Process interfacing via an automation system (PLC, PC)
9.8 Remote client
SIMATIC MV500
212 Operating Instructions, 03/2021, C79000-G8976-C494-05
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importdp"
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importserial"
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importsec"
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importcodes"
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importcustomgui"
<on|off>
[REMOTEXMLUPLOADPARA]
Content-Disposition: form-data; name="importremoteclientip"
<on|off>
[REMOTEXMLUPLOADPARA]
"
Response
Structure and properties of the response:
• HTTP status code 200 (OK)
• Data:
– "2": XML upload and import were only partially successful.
The optical reader restarts. The XML import must be performed again via the WBM to
obtain error analysis.
– "1": XML upload and import was successful.
The optical reader restarts.
– "0": Import error.
The XML import must be performed again via the WBM to obtain error analysis. The
"IN_OP" bit is set and access via the WBM is allowed again.