Siemens Simatic S7-300 - A.1 How to Assign the Parameters for Signal Modules in the User Program

A-1
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Parameter Sets for Signal Modules
In this chapter
Section Contents Page
A.1 How to Assign the Parameters for Signal Modules in the User
Program
A-1
A.2 Parameters of the Digital Input Modules A-3
A.3 Parameters of the Digital Output Modules A-5
A.4 Parameters of the Analog Input Modules A-7
A.5 Parameters of the SM 331; AI 8 x RTD A-11
A.6 Parameters of the SM 331; AI 8 x TC A-19
A.7 Parameters of the SM 331; AI 8 x 13 bits A-27
A.8 Parameters of the SM 331; AI 8 x 16 bits A-30
A.9 Parameters of the Analog Output Modules A-36
A.10 Parameters of the SM 332; AO 8 x 12 bits A-39
A.11 Parameters of the Analog Input/Output Modules A-41
A.1 How to Assign the Parameters for Signal Modules in the
User Program
Parameter assignment in the user program
You have already assigned parameters to the modules in STEP 7.
In the user program, you can use a SFC:
• To reassign parameters to the module and
• To transfer the parameters from the CPU to the addressed signal module
A