Siemens SIMATIC - Dimensional drawings

S7-300 Module data
Manual, 06/2017, A5E00105505-AJ
598
Dimensional drawings
C
Introduction
This appendix contains the dimensional drawings of the most important components of an
S7-300. The specified dimensions are required to determine the dimensions of an S7-300
configuration. Make allowances for the dimensions of an S7-300 configuration when you
install the system in cabinets, control rooms, etc. This appendix does not include the
dimensional drawings of S7-300 or M7-300 CPUs, or of IM 153-1. These are included in the
relevant manuals.
Contents
This appendix contains the dimensional drawings of the S7-300 components listed below.
● Mounting rails
● Power supply modules
● Interface modules
● Signal modules
● Accessories