Maintenance
9
9.1 General
Through careful and regular maintenance, inspections and overhauls, you can detect faults at
an early stage and resolve them. This means that you can avoid consequential damage.
Operating situations and characteristics can vary widely. For this reason, only general
maintenance intervals can be specied here. Maintenance intervals should therefore be
scheduled to suit the local conditions (dirt, starting frequency, load, etc.).
Comply with the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page12).
• Comply with the applicable national and sector-specic regulations.
• When using the motor within the European Union, comply with the specications laid down
in EN50110‑1 regarding safe operation of electrical equipment.
Carefully comply with the IEC/EN6007917 standard or according to the appropriate country
regulations when carrying out all service and maintenance work on the machine.
When making changes or repairs to listed machines, maintain the corresponding design
standards! These machines are labeled on the rating plate with the following markings.
UKCA marking
Great Britain (England, Wales and Scotland)
Customs union Eurasia
Eurasian customs union
Explosion-protected
China Compulsory Certication
Note
Please contact the service center (Page 12), if you require support with service, maintenance or
repair.
1MB..1/2/3/4 - shaft heights 63 ... 355
Operating Instructions, 11/2023, A5E52779900A 115
To Next Page
Loading...
Need help?
General
