1.5 Important product information
Intended use of the machines
These machines are intended for industrial installations. They comply with the harmonized
standards of the series EN/IEC60034 (VDE 0530). It is prohibited to use these motors in
hazardous zones if the marking on the motor rating plate does not explicitly permit line or
converter operation. If other/more wide-ranging demands (e.g. protection so that they cannot
be touched by children) are made in special cases – i.e. use in non-industrial installations – these
conditions must be ensured by the customer.
Note
EU Machinery Directive
Low-voltage motors are components designed for installation in machines in accordance with
the EU Machinery Directive. Commissioning is prohibited until it has been absolutely identied
that the end product is in conformance with this Directive. Comply with standard EN/ IEC
60204-1.
Introduction
1.5Important product information
1MB..1/2/3/4 - shaft heights 63 ... 355
14 Operating Instructions, 11/2023, A5E52779900A
To Next Page
Loading...
Need help?
General
