11.4 Preparing for disassembly
Disassembly of the machine must be carried out and/or supervised by qualied personnel with
appropriate expert knowledge.
1. Contact a certied waste disposal organization in your vicinity. Clarify what is expected in
terms of the quality of dismantling the machine and provision of the components.
2. Carefully follow the 5 safety rules (Page16).
3. Disconnect all electrical connections and remove all cables.
4. Remove all liquids e.g. oil and cooling liquids. Collect the liquids separately and dispose of
them in a professional manner.
5. Detach the machine xings.
6. Transport the machine to a suitable location for disassembly.
11.5 Dismantling the machine
Dismantle the machine using the general procedures commonly used in mechanical
engineering.
WARNING
Machine parts can fall
The machine is made up of heavy parts. These parts are liable to fall during dismantling. This
can result in death, serious injury or material damage.
• Before you release any machine parts, secure them so that they cannot fall.
11.6 Disposal of components
Components
The machines consist mainly of steel and various proportions of copper and aluminum. Metals
are generally considered to be unlimitedly recyclable.
Sort the components for recycling according to whether they are:
• Iron and steel
• Aluminum
• Non-ferrous metal, e.g. windings
The winding insulation is incinerated during copper recycling.
• Insulating materials
• Cables and wires
• Electronic waste
Disposal
11.6Disposal of components
1MB..1/2/3/4 - shaft heights 63 ... 355
166 Operating Instructions, 11/2023, A5E52779900A
To Next Page
Loading...
Need help?
General
