In an explosive atmosphere, there is a risk of an explosion. This can result in death, serious
injury or material damage.
• When cleaning, ensure that there is absolutely no explosive atmosphere present.
• Comply with ESD protective measures.
• Avoid carrying out work specied above on non-metallic parts, e.g. foam rubber for noise
dampeners/attenuators.
• Use the tested, original paint when recoating or touching up.
• Carefully check repaired or subsequently applied coating systems to ensure that they strictly
comply with the electrostatic requirements according to IEC/EN 60079-0.
• Do not subsequently attach any additional plates or labels to the machine that do not comply
with the electrostatic requirements relating to protection against explosion.
• Clean the plastic parts and components so that absolutely no static charging occurs.
• Do not use compressed air for cleaning.
• Minimize the risk of electrostatic charging by applying eective measures according to IEC
60079-32-1.
2.1.7 Electromagnetic compatibility
Electromagnetic compatibility
This machine is designed in accordance with IEC/EN60034, and when used as specied it
satises the requirements of European Directive 2014/30/EU on Electromagnetic Compatibility.
2.1.8 Interference immunity
By selecting suitable signal cables and evaluation units, ensure that the interference immunity
of the machine is not diminished.
2.1.9 Inuence on the line power supply through a strongly irregular torque
A strongly irregular torque, for example with the drive of a reciprocating motor, forces a non-
sinusoidal motor current. The emerging harmonics can have an impermissible inuence on the
line power supply via the connection lines.
Safety information
2.1General safety instructions
1MB..1/2/3/4 - shaft heights 63 ... 355
Operating Instructions, 11/2023, A5E52779900A 21
To Next Page
Loading...
Need help?
General
