Siemens SIMOTION ADI4 - Page 74

Commissioning
4.2 Absolute encoder (SSI), single-turn
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
74 Manual, 05/2009, 6FC5 297-0BA01-0BP6
SIMOTION/TCPU settings
After you have created a new encoder in the project navigator of SIMOTION SCOUT under
"EXTERNAL ENCODERS" and have assigned the technology object parameters in the
displayed dialog boxes, e.g. "Axis Type" and "Units", the encoder data must be entered in
the "Encoder Assignment" and "Encoder - Data" dialog boxes.
1. Settings in the "Encoder Assignment" dialog box

66,

$[LVFRQILJXUDWLRQ$[LVB(QFRGHUDVVLJQPHQW
:KHUHLVWKHSRVLWLRQHQFRGHUFRQQHFWHG"
$[LVW\SH
8QLWV
(QFRGHU'DWD
(QFDVVLJQPHQW
'ULYHDVVLJQPHQW
0RGXOR
:KLFKPHVVDJHIUDPHW\SHGR\RXZDQWWRXVHIRUWKHGDWDWUDQVIHU"
6WDQGDUGPHVVDJHIUDPH
(QFRGHUW\SH
/RJLFDO+:DGGUHVVHV ,QSXW 2XWSXW
(QFRGHUPRGH
%DFN 1H[W! +HOS&DQFHO
0HDVXULQJV\VWHP
$EVROXWHHQFRGHU
5RWDU\HQFRGHUV\VWHP
$',(QFRGHU
+HUH\RXVSHFLI\WKHHQFRGHUXVHGIRUWKLVD[LV<RXFDQVHOHFW
VSHFLILFHQFRGHUFRQQHFWLRQW\SHVIRUWKLVSXUSRVH
Figure 4-3 Encoder assignment settings