Siemens SINAMICS G120C Function Manual

Commissioning
5
5.1 About this chapter
What can you find in this Chapter?
In this chapter, you will find answers to the following questions:
● Which sequence is recommended when commissioning the inverter?
● What tool do I need for commissioning?
● How do I restore the factory settings of the safety functions?
● In SINAMICS G120, is it permissible to jointly use the safety functions according to SIL 2
and SIL 3?
● How do I commission the safety functions?
● How do I configure communication via PROFIsafe in the inverter?
● How do I transfer the parameters of the safety functions to other inverters?
● Why is it necessary to "Accept safety functions"?
● What does accepting the safety functions involve?
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 101

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating