Siemens SINAMICS G120C Function Manual

Operation
6
6.1 About this chapter
What can you find in this Chapter?
In this chapter, you will find answers to the following questions:
● What do I have to do to maintain the guaranteed failure probability of the safety functions
during the mission time?
● How does the drive respond when you select and deselect one of the safety functions?
● What do I need to observe when the motor is switched off or switched on with a safety
function active?
● How does the drive respond to a discrepancy signal at a fail-safe digital input?
● How does the drive respond to limit value violations or if internal monitoring functions
respond?
● How do I acknowledge safety function faults?
● How do the safety functions mutually influence one another, if I select more than one safety
function?
● What do the alarm and fault messages of the safety functions mean?
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 213

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating