Siemens SINAMICS G120C Function Manual

5.10 Configuring safety functions and PROFIsafe with Startdrive
5.10.1 Configuring safety functions
Precondition
You are offline with Startdrive.
Procedure with Startdrive
Proceed as follows to configure the safety functions:
1. Select "Select safety functionality".

2. Define the configuration of the safety functions:
&
%
$
– (A) You want to exclusively use the basic inverter functions.
– (B) You want to use the extended safety functions.
– (C) This option is only available with a PM240‑2 or PM240P‑2 FSD ... FSF Power
Module. Select this option if you only use the "STO via Power Module terminals" function.


Commissioning
5.10 Configuring safety functions and PROFIsafe with Startdrive
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 119

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating