Siemens SINAMICS G120C Function Manual

6.5.5 Limit value violation when SS1 is active
Drive response
If motion monitoring detects a fault when SS1 is active, the inverter safely switches off the
motor torque (STOP A).
6SHHG
W
W
,QWHUQDOHYHQW
6$06%5DFWLYH
66DFWLYH
672DFWLYH
W
'HVHOHFW66
212))
&RQYHUWHULGHQWLILHV
DIDXOW
*UHHQRQ5HGIODVKHVTXLFNO\*UHHQRQ
<HOORZRQ
<HOORZ
TXLFN
<HOORZVORZ
<HOORZRQ
6WDQGDUGDFNQRZOHGJH
/('5'<
/('6$)(
6723$
6$0
Figure 6-23 General fault response of safety function SS1 (as an example: SS1 with acceleration
monitoring)
Inverter signal Parame‐
ter
Included in the PRO‐
FIsafe telegram
Can be intercon‐
nected with
F-DI F-DO
Internal event r9722.7 ✓ --- ✓
STO active (extended functions) r9722.0 ✓ --- ✓
SS1 active (extended functions) r9722.1 ✓ --- ✓
Deselect SS1 (extended functions) r9720.1 ✓ ✓ ---
SAM/SBR active r9723.16 --- --- ---
"Standard" acknowledgment p2103 --- --- ---
ON/OFF1 r0054.0 --- --- ---
Operation
6.5 Safe Stop 1 (SS1)
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 251

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating