Siemens SINAMICS G120C Function Manual

A.2.9 Acceptance test for F-DI status in PROFIsafe telegram 900...............................................412
A.3 Documentation for acceptance............................................................................................413
A.3.1 Creating logs with the settings of the safety functions.........................................................413
A.3.2 Example of machine documentation....................................................................................415
A.3.3 Documenting the settings for the basic functions, firmware V4.4 ... V4.7 SP6....................417
A.3.4 Protocol of the settings for the extended functions, firmware V4.4 ... V4.7 SP6..................418
A.4 Standards and specifications...............................................................................................421
A.4.1 General information..............................................................................................................421
A.4.1.1 Aims.....................................................................................................................................421
A.4.1.2 Functional safety..................................................................................................................421
A.4.2 Safety of machinery in Europe.............................................................................................422
A.4.2.1 Machinery Directive..............................................................................................................422
A.4.2.2 Harmonized European Standards........................................................................................423
A.4.2.3 Standards for implementing safety-related controllers.........................................................424
A.4.2.4 DIN EN ISO 13849-1 (replaces EN 954-1)..........................................................................425
A.4.2.5 EN 62061.............................................................................................................................426
A.4.2.6 Series of standards IEC 61508 (VDE 0803)........................................................................428
A.4.2.7 Risk analysis/assessment....................................................................................................428
A.4.2.8 Risk reduction......................................................................................................................430
A.4.2.9 Residual risk.........................................................................................................................430
A.4.2.10 EC declaration of conformity................................................................................................430
A.4.3 Machine safety in the USA...................................................................................................430
A.4.3.1 Minimum requirements of the OSHA...................................................................................431
A.4.3.2 NRTL listing..........................................................................................................................431
A.4.3.3 NFPA 79...............................................................................................................................431
A.4.3.4 ANSI B11.............................................................................................................................432
A.4.4 Machine safety in Japan......................................................................................................432
A.4.5 Equipment regulations.........................................................................................................434
A.4.6 Other safety-related issues..................................................................................................434
A.4.6.1 Information sheets issued by the Employer's Liability Insurance Association......................434
A.4.6.2 Additional references...........................................................................................................434
A.5 Manuals and technical support............................................................................................435
A.5.1 Overview of the manuals......................................................................................................435
A.5.2 Configuring support..............................................................................................................438
A.5.3 Product Support...................................................................................................................440
A.6 Mistakes and improvements................................................................................................441
Index.........................................................................................................................................................443
Table of contents
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
12 Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating