Siemens SINAMICS G120C Function Manual

3. Press the "Safe basic functions" button:
A
$
%
&

Set the following:
– (A) Set the monitoring time to the maximum value (9000 hours). This means that the
forced checking procedure monitoring for the basic functions is deactivated.
– This monitoring is not required when using the extended functions, as the forced
checking procedure for the extended functions also includes the forced checking
procedure for the basic functions.
– (B) Setting not required.
– (C) If required, interconnected the status of the STO function, e.g. with a digital output
of your choice.
4. Close the screen form.
You have set the forced checking procedure (test stop) of the extended functions.
Commissioning
5.12 Setting extended functions
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
148 Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating