Siemens SINAMICS G120C Function Manual

What applications are described?
The "Safety Integrated" Function Manual provides information, procedures and operator
actions for the following situations:
● Introductory and simplified description of the inverter safety functions
● Controlling safety functions via fail-safe digital inputs or PROFIsafe
● Commissioning and acceptance test of the safety functions
● Response of the inverter with active safety functions
● Replacing an inverter where the safety functions are enabled.
● Diagnostics of the safety functions
The appendix contains an overview of the applicable regulations and standards for using the
safety functions.
What other information do you need?
The "Safety Integrated" Function Manual is not sufficient when installing or commissioning
"Standard" inverter functions. An overview of the documentation available and the associated
applications.
Overview of the manuals (Page 435)
What is the meaning of the symbols in the manual?
Reference to further information in the manual
An operating instruction starts here.
This concludes the operating instruction.
Download from the Internet
DVD that can be ordered


Introduction
2.1 About this manual
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 17

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating