Siemens SINAMICS G120C Function Manual

Chapter You can find answers to the following questions in the chapter:
System properties
(Page 367)
● How long may you operate the inverter?
● In which time intervals must you initiate the inverter self test?
● What is the probability of failure of the inverter safety functions?
● In which time does the drive respond when selecting a safety function?
● When a safety function is active, in which time does the drive respond to a motor
malfunction?
● According to which standards are the inverter safety function certified?
● Where can you find certifications for the inverter?
● What is the technical data of the Safe Brake Relay?
Appendix (Page 381)
● What does a typical acceptance for a safety function look like?
● As machine builder or company operating a machine, which standards and
regulations must you comply with?
● Where can you find additional information about the inverter?
Introduction
2.2 Navigator through the "Safety Integrated" Function Manual
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 19

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating