Siemens SINAMICS G120C Function Manual



You have loaded certificates relevant for Safety Integrated from the Internet.
EC Declaration of Conformity
According to Annex IV of the machinery directive, drives equipped with Safety Integrated are
defined as "Logic units for safety functions" and therefore as a safety component. The
machinery directive specifies that safety components should be handled just like machines.
As a consequence, safety components require a CE marking.
As machine builder, you must provide documentation that you create for the CE marking of
the machine, together with the EC Declaration of Conformity for the products that have been
installed.
The current EC Declarations of Conformity for the inverter are in the Internet:
EC Declaration of Conformity (http://support.automation.siemens.com/WW/view/en/
67385845)
System properties
8.3 Certification
Safety Integrated - SINAMICS G110M, G120, G120C, G120D and SIMATIC ET 200pro FC-2
Function Manual, 01/2017, FW V4.7 SP6, A5E34261271B AD 371

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating