Siemens SINUMERIK 802D Training Manual

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 5
C83
C83
Section 2
Working Plane Selection
G00 G90 G95 G40 G17
LIMS=2500
G54
T1 D1 ;CALL DRIL
L TOOL
G94 S1=10
00 F150 M1=03
;START SPI
NDLE
G00 X0.0 Z2.0 ;RAPID T
O SAFE POSITION
G01 Z-10.0 ;DRILL
Z-10.0
G00 Z2.0 ;RAPID TO SAFE POSITION
G00 X150.0 Z150.0 ;TOOL C
HANGE POSITION
G18 ;SET PLANE TO DEF
AULT
M30
G00 G90 G95 G40 G19
LIMS=2500
G54
T2 D1 ;CALL DRIL
L TOOL
G95 S2=10
00 F0.15 M2=03
;START SPI
NDLE FOR LIVE TOOLING
G00 X20.0 Z2.0 ;RAPID T
O SAFE POSITION
Z-30.0 ;RAPID T
O SAFE POSITION
G01 X10.0 ;DRILL X10.0
G00
X20.0 ;
RAPID T
O SAFE POSITION
Z2.0 ;RAPID T
O SAFE POSITION
G00 X150.0 Z150.0 ;TOOL C
HANGE POSITION
G18
;SET PLANE TO DEFAULT
Typical program using G17 plane drilling in the X
/
Y axis plane
Typical program using G19 plane drilling in the Y/
Z axis plane
The same planes apply when milling, the first part of any drilling or milling
cycle is the i
nfeed
direct
ion (or movement).
Take note of the axis that
is moving when drilling (X
axis infeed di
rection)
Selected
plane
Selected
plane
Default
plane
Default
plane
Take note of the axis that
is moving when drilling (Z
axis infeed di
rection)

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English