Siemens SINUMERIK 802D Training Manual

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 16
C99
C99
Section 4
Drilling cycles
To create the rest of the program, you will have to use CYCLE81 and CY-
CLE84 and HOLES2, remembering t
o make the correct CYCLES modal
and non-modal.
Final program. For Centre Drill, Drill and Tap.

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English