Siemens SINUMERIK 810D Operation & Programming Manual

11
08.02 Alarms and Messages
11.2 Alarms with ManualTurn
11
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 11-179
Reaction Alarm display
NC start disable
Remedy Replace key
111 301
NC stop key defective
Explanation Checkback signal to PLC user program that NC stop key is defective,
i.e. N.C. and N.O. signal = 1
Reaction Alarm display
NC start disable
Remedy Replace key
111 302
Spindle start key defective
Explanation Checkback signal to PLC user program that spindle start key is
defective, i.e. N.C. and N.O. signal = 1
Reaction Alarm display
NC start disable
Remedy Replace key
111 303
Spindle stop key defective
Explanation Checkback signal to PLC user program that spindle stop key is
defective, i.e. N.C. and N.O. signal = 1
Reaction Alarm display
NC start disable
Remedy Replace key
111 304
Connection to PLC broken
Explanation Checkback signal to PLC user program that connection to
MANUALTURN is broken.
Reaction Alarm display
MANUALTURN-PLC terminated
Remedy Check PLC user program.
111 305
Asynchronous subroutine not processed
Note In the asynchronous subroutine, internal settings in the NC are
triggered by the user interface. If any of the alarms 111 306 to
111 310 is triggered, these settings cannot be executed.
Reaction Alarm display
Remedy Press NC reset.
111 306
Error on selection or deselection of constant cutting speed
111 307
Error on resetting handwheel offset
111 308
Error on setting spindle speed upper limit
111 309
Error on selecting tool
111 310
Error on selecting zero offset

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English