15
04.00 Tables
15.2 List of s
stem variables
15
ï›™
Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
15-521
Identifier Type Description: System variable/value range/index Part pro Sync O S
...
... ...
$TC_SCP31
REAL Offset for $TC_DP11: $TC_SCP31[t,d] analogous to $TC_DP20[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP31[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_SCP33
REAL Offset for $TC_DP3: $TC_SCP33[t,d] analogous to $TC_DP12[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP33[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_SCP34
REAL Offset for $TC_DP4: $TC_SCP34[t,d] analogous to $TC_DP13[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP34[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
...
...
$TC_SCP41
REAL Offset for $TC_DP11: $TC_SCP41[t,d] analogous to $TC_DP20[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP41[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_SCP43
REAL Offset for $TC_DP3: $TC_SCP43[t,d] analogous to $TC_DP12[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP43[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
$TC_SCP44
REAL Offset for $TC_DP4: $TC_SCP44[t,d] analogous to $TC_DP13[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP44[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
...
...
$TC_SCP51
REAL Offset for $TC_DP11: $TC_SCP51[t,d] analogous to $TC_DP20[t,d]
With active 'Flat D number management' function, the syntax is as
follows:
$TC_SCP51[d]
t: T number 1–32000
d: Cutting edge number/D number 1–32000
RW 5
To Next Page
Loading...
Need help?
General
