Siemens SINUMERIK 840DE

Programming Motion Commands
4.15 Thread cutting with constant lead (G33)
Fundamentals
4-52 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
=
;
=
.
5XQLQSDWK
5XQRXWSDWK
Face thread
The face thread is described by
• Thread diameter, preferentially in X direction and
• Thread lead, preferentially with I.
Otherwise, the procedure is the same as for cylindrical threads.
,
;
/HDG
'LDPHWHU
Taper thread
The taper thread is described by the end point in the longitudinal and facing direction (taper
contour) and the thread lead.
The taper contour is entered in Cartesian coordinates X, Y, Z in absolute or incremental
dimensions - preferentially in the X and Z direction for machining on turning machines.
Allowance must also be made for the run-in and run-out paths, across which the feed is
accelerated or decelerated.