Siemens SINUMERIK 840DE

Programming Motion Commands
4.15 Thread cutting with constant lead (G33)
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
4-53
The parameter for the lead is based on the taper angle (calculated from the longitudinal axis
lead angle <45° to the outside of the taper lead angle >45°).
!r
,
;
=
r
.
;
=
Start point offset SF - production of multi-turn threads
Threads with offset cuts are programmed by specifying starting point offsets in the G33
block.
The start point offset is specified as an absolute angle position at address SF=. The
associated setting data is changed accordingly.
Example: SF=45
Meaning: Start offset 45°
Value range: 0.0000 to 359.999 degrees
;
=
6WDUWSRLQW
RIIVHWLQ¡
6WDUWDQJOH
IRUWKUHDG
VHWWLQJGDWD