Tables
12.1 List of statements
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-5
CUT3DF
5
3D cutter compensation type 3-dimensional
face milling
m 22
CUT3DFF
5
3D cutter compensation type 3-dimensional
face milling with constant tool orientation
dependent on the current frame
m 22
CUT3DFS
5
3D cutter compensation type 3-dimensional
face milling with constant tool orientation
independent of the current frame
m 22
CUTCONOF
1
Constant radius compensation OFF m 40
CUTCONON Constant radius compensation ON m 40
D Tool offset number 1, ...
32 000
contains offset
data for a
specific tool T...
;D0 → offset
values for a tool
D...
DC Absolute dimensions for rotary
axes, approach position directly
A=DC(...) B=DC(...)
C=DC(...)
SPOS=DC(...)
s
DIAMCYCOF Radius programming for G90/G91: ON. The G-
code of this group that was last active remains
active for display
Radius
programming of
most recent G-
code
m 29
DIAMOF
1
Diameter programming: OFF
(Diametral programming OFF)
Radius
programming for
G90/G91
m 29
DIAMON Diametral programming: ON
(Diametral programming ON)
Diametral
programming for
G90/G91
m 29
DIAM90 Diametral programming: for G90, radius progr.
for G91
m 29
DILF Length for lift fast m
DISC Transition circle overshoot - radius
compensation
0, ..., 100 m
DISPR Distance for repositioning Real, w/o
signs
s
DISR Distance for repositioning Real, w/o
signs
s
DITE Thread run-out path Real m
DITS Thread run-in path Real m
DL Total tool offset INT m
DRFOF Deactivate the handwheel offsets (DRF) m
DRIVE
7
Velocity-dependent path acceleration m 21
EAUTO Definition of last spline section by the last 3
points (end not a node)
m 20
To Next Page
Loading...
