Tables
12.1 List of statements
Fundamentals
12-4 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
CFTCP Constant feed in tool-center- point (center-point
path)
m 16
CFIN Constant feed at internal radius only, not at
external radius
m 16
CHF
CHR
Chamfer; value = length of
chamfer
Chamfer; value = width of
chamfer in direction of
movement (chamfer)
Real, w/o signs S
CHKDNO Check for unique D numbers
CIP Circular interpolation through intermediate point CIP X... Y... Z...
I1=... J1=... K1=...
m 1
COMPOF
1,6
Compressor OFF m 30
COMPON
6
Compressor ON m 30
COMPCURV Compressor ON: Polynomials with constant
curvature
m 30
COMPCAD Compressor ON: Surface quality CAD program m 30
CP continuous path; path motion m 49
CPRECOF
1,6
Programmable contour precision OFF
m 39
CPRECON
6
Programmable contour precision ON
m 39
CR Circle radius Real, w/o signs s
CROTS Programmable frame rotations with solid angles
(rotation in the specified axes)
CROTS X... Y...
CROTS Z... X...
CROTS Y... Z...
;separate
CROTS RPL= block
s
CSPLINE Cubic spline m 1
CT Circle with tangential transition CT X... Y.... Z... m 1
CUT2D
1
2½D cutter compensation (cutter compensation
type 2 dimensional)
m 22
CUT2DF 2½D tool offset (cutter compensation type 2
dimensional frame); The tool offset acts in
relation to the current frame (inclined plane)
m 22
CUT3DC
5
3D cutter compensation type 3-dimensional
circumference milling
m 22
CUT3DCC
5
Cutter compensation type 3-dimensional
circumference milling with limit surfaces
m 22
CUT3DCCD
5
Cutter compensation type 3-dimensional
circumference milling with limit surfaces with
differential tool
m 22
To Next Page
Loading...
