Tables
12.1 List of statements
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-7
FIFOCTRL Control of preprocessing buffer m 4
FL Speed limit for synchronized axes
(feed limit)
Real, w/o
signs
The unit set with
G93, G94, G95
is applicable
(max. rapid
traverse)
FL[axis] =… m
FLIN
6
Feed linear variable (feed linear) Acts on feed
with G93 and
G94
m 37
FMA Feed multiple axial
Real, w/o
signs
m
FNORM
1,6
Feed normal to DIN 66025 m 37
FP Fixed point: number of fixed points
to be approached
Integer,
w/o signs
G75 FP=1 s
FPR Identification for rotary axis 0.001, ...,
999999.9
99
FPR (rotary axis)
FPRAOF Deactivate revolutional feedrate
FPRAON Activate revolutional feedrate
FRC Feed for radius and chamfer s
FRCM Feed for radius and chamfer, modal m
FTOCOF
1,6
Online fine tool offset OFF
m 33
FTOCON
6
Online fine tool offset ON
m 33
FXS Travel to fixed stop ON
Integer,
w/o signs
1 = select,
0 = deselect
m
FXST Torque limit for travel to fixed stop
(fixed stop torque)
% parameter
optional
m
FXSW Monitoring window for travel to fixed
stop
(fixed stop window)
mm, inch
or
degrees
parameter
optional
G Functions
G G function (preparatory function)
The G functions are divided into G groups.
Only one G function from one group can be
written in one block.
A G function can either be modal (until
canceled by another function from the
same group), or non-modal (only effective
for the block it is written in).
Only integer,
predefined
values
G...
To Next Page
Loading...
