Tables
12.1 List of statements
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-21
Legend:
1
Default setting at beginning of program (factory settings of the control, if nothing else programmed).
2
The groups are numbered according to the table in section "List of G functions/preparatory functions"
3
Absolute end points: modal; incremental end points: non-modal; otherwise modal/non-modal (m, n) depending on syntax
of G function.
4
As arc centers, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The address
modification is ignored when the parameters have other meanings (e.g., thread pitch).
5
The vocabulary word is not valid for SINUMERIK 810D
6
The vocabulary word is not valid for SINUMERIK 810D/NCU571
7
The vocabulary word is only valid for SINUMERIK FM-NC
8
The OEM can add two extra interpolation types. The names can be changed by the OEM.
9
Extended address notation cannot be used for these functions.
To Next Page
Loading...
