Tables
12.3 List of G functions/preparatory functions
Fundamentals
12-32 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
G59 16. Programmable offset, additive axial substitution X n
ROTS 17. Rotation with solid angles X n
AROTS 18. Additive rotation with solid angles X n
Group 4: FIFO
Name No. Meaning X m/n SAG MM
STARTFIFO 1. Start FIFO
Execute and simultaneously fill preprocessing memory
m Def.
STOPFIFO 2. STOP FIFO,
Stop machining; fill preprocessing memory until STARTFIFO is detected,
FIFO full or end of program
m
FIFOCTRL 3. FIFO CTRL,
Preprocessing memory control
m
Group 6: Plane selection
Name No. Meaning X m/n SAG MM
G17 1. Plane selection 1st - 2nd geometry axis m Def.
G18 2. Plane selection 3rd - 1st geometry axis m
G19 3. Plane selection 2nd - 3rd geometry axis m
Group 7: Tool radius compensation
Name No. Meaning X m/n SAG MM
G40 1. No tool radius compensation m Def.
G41 2. Tool radius compensation left of contour X m
G42 3. Tool radius compensation right of contour X m
Group 8: Settable zero offset
Name No. Meaning X m/n SAG MM
G500 1. Deactivate all settable G54-G57 frames if G500 does not contain a value m Def.
G54 2. Settable zero offset m
G55 3. Settable zero offset m
G56 4. Settable zero offset m
G57 5. Settable zero offset m
G505 6. Settable zero offset m
G5xx n+1 nth settable zero offset m
G599 100. Settable zero offset m
The G functions of this group activate a settable user frame $P_UIFR[ ].
G54 corresponds to frame $P_UIFR[1], G505 corresponds to frame $P_UIFR[5].
To Next Page
Loading...
