Detailed description
2.12 Block descriptions
Power Line Basic PLC Program (P3)
2-136 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Parameterization:
Parameterization
Signal Type Value range Meaning
PIService ANY PI.DELETE Delete cutting edge
Unit INT TOA
WVar1 INT T number of tool for
which the cutting edge
must be deleted. A
setting of 00000 states
that the cutting edge
should not refer to any
particular tool (absolute
D number).
WVar2 INT 1 - 9 or
01 - 31999
Edge number of cutting
edge that must be
deleted
Empty location search
TMFPBP
Function:
(dependent on parameter assignment)
See description in FB 7.
Complex search using search screen forms
TSEARC
Function:
(dependent on parameter assignment)
The PI service allows you to search for tools with specified properties within a search domain
(in one or more magazines starting and ending at a specific location). The specified
properties refer only to data of the tools and their cutting edges. The PI service is only
available if tool management is activated. You can define a search direction and the number
of hits for the PI service (e.g., one tool for the next tool with matching properties or all tools
with the specified properties). As a result of this service, the user who made the call receives
a list of the internal T numbers of the tools found.
The search criteria can only be specified as AND operations. If an application needs to
define an OR operation for the search criteria, it must first execute a series of queries with
AND criteria and then combine/evaluate the results of the individual queries.
To Next Page
Loading...
Need help?
General
