Data Lists
5.1 Machine data
Axis Types, Coordinate Systems, Frames (K2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
5-3
Number Identifier: $MC_ Description
24000 FRAME_ADD_COMPONENTS Separate programming/modification of additively
programmable frame components
24002 CHBFRAME_RESET_MASK RESET response of channelspecific basic frames
24004 CHBFRAME_POWERON_MASK POWER ON response of channelspecific
basic frames
24006 CHSFRAME_RESET_MASK RESET response of channelspecific system frames
24007 CHSFRAME_RESET_CLEAR_MASK Clear system frames on RESET
24008 CHSFRAME_POWERON_MASK Delete system frames on POWER ON
24010 PFRAME_RESET_MODE RESET mode for programmable frame
24020 FRAME_SUPPRESS_MODE Positions for frame suppression
24030 FRAME_ACT_SET SZS coordinate system setting
24040 FRAME_ADAPT_MODE Adapting active frames
24050 FRAME_SAA_MODE Save and activate data management frames
24805 TRACYL_ROT_AX_FRAME_1 Rotary axis offset TRACYL 1
24855 TRACYL_ROT_AX_FRAME_2 Rotary axis offset TRACYL 2
24905 TRANSMIT_ROT_AX_FRAME_1 Rotary axis offset TRANSMIT1
24955 TRANSMIT_ROT_AX_FRAME_2 Rotary axis offset TRANSMIT2
28081 MM_NUM_BASE_FRAMES Number of channel/specific Basic frames
28082 MM_SYSTEM_FRAME_FRAMES Configuration screen form for channel-specific system
frames
28560 MM_SEARCH_RUN_RESTORE_MODE Restore data after a simulation
(SW 7.1 and higher)
5.1.4 Axis/spindle-specific machine data
Number Identifier: $MA_ Description
32074 FRAME_OR_CORRPOS_NOTALLOWED FRAME or HL offset is not permitted
35000 SPIND_ASSIGN_TO_MACHAX Assignment spindle to machine axis
To Next Page
Loading...
Need help?
General
