Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
5-1
Data Lists
5
5.1 5.1 Machine data
5.1.1 General machine data
5.1.1.1 HMIspecific machine data
Number
ADV EMB
Identifier: $MM_ Description
9421 9421 MA_AXES_SHOW_GEO_FIRST Display geo axes of channel first
9422 9422 MA_PRESET_MODE PRESET/basic offset in JOG.
9423 9423 MA_MAX_SKP_LEVEL Maximum number of skip levels
5.1.1.2 NC-specific machine data
Number Identifier: $MN_ Description
10010 ASSIGN_CHAN_TO_MODE_GROUP Channel valid in mode group
10280 PROG_FUNCTION_MASK Compare commands ">" and "<" compatible to
SW 6.3
10617 FRAME_SAVE_MASK Response of frames to subroutine return jump with
SAVE
10700 PREPROCESSING_LEVEL Program preprocessing level
10702 IGNORE_SINGLEBLOCK_MASK Prevent single-block stop
10707 PROG_TEST_MASK Program test modes
10708 SERUPRO_MASK Block change modes
10710 PROG_SD_RESET_SAVE_TAB Setting data to be updated
10713 M_NO_FCT_STOPRE M function with preprocessing stop
10715 M_NO_FCT_CYCLE M function to be replaced by subroutine
10716 M_NO_FCT_CYCLE_NAME Subroutine name for M function replacement
10717 T_NO_FCT_CYCLE_NAME Name of tool change cycle for T function
10718 M_NO_FCT_CYCLE_PAR M function replacement with parameters
10719 T_NO_FCT_CYCLE_MODE Parameter assignment for T function replacement
To Next Page
Loading...
Need help?
General
