Index
Various NC/PLC Interface Signals and Functions (A2)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Index-3
MD28150 $MC_MM_NUM_VDIVAR_ELEMENTS, 2-30
MD28530 $MC_MM_PATH_VELO_SEGMENTS, 2-27
MD31050 $MA_DRIVE_AX_RATIO_DENOM, 4-1
MD31060 $MA_DRIVE_AX_RATIO_NUMERA, 4-1
MD32200 $MA_POSCTRL_GAIN, 2-16, 4-1
MD32800 $MA_EQUIV_CURRCTRL_TIME, 4-2
MD32810 $MA_EQUIV_SPEEDCTRL_TIME, 4-2
MD32910 $MA_DYN_MATCH_TIME, 4-2
MD33050 $MA_LUBRICATION_DIST, 2-18
MD35130 $MA_AX_VELO_LIMIT, 4-2
MD35590 $MA_PARAMSET_CHANGE_ENABLE,
2-16, 4-1
MD36060 $MA_STANDSTILL_VELO_TOL, 2-16, 2-17
MD36610 $MA_AX_EMERGENCY_STOP_TIME, 2-14
MD36620 $MA_SERVO_DISABLE_DELAY_TIME,
2-14
MD9000 $MM_LCD_CONTRAST, 2-23
MD9001 $MM_DISPLAY_TYPE, 2-23
MD9003 $MM_FIRST_LANGUAGE, 2-23
MD9004 $MM_DISPLAY_RESOLUTION, 2-23
MD9006 $MM_DISPLAY_BLACK_TIME, 2-5
MMC alarm, 2-4
MMC CPU1 Ready, 2-3
MMC2 CPU Ready, 2-3
Monitor type, 2-23
N
nact
|nact| < nmin, 2-22
|nact| < nx, 2-22
nact = nsetp, 2-22
NCK alarm is active, 2-4
NCK alarm with processing stop, 2-4
NCK battery alarm, 2-4
NCK CPU Ready, 2-3
P
Password, 2-32
Resetting, 2-33
Setting, 2-32
PLC/NCK interface, 2-1
Position controller active, 2-17
Position measuring system, 2-12
Protection levels, 2-35
R
Ramp-up function completed, 2-21
Read/write PLC variable, 2-27
Recall alarms, 2-6
S
Servo enable, 2-13
Signals
Alarm signals, 2-4
Axis/spindlespecific (DB31, etc.), 2-2, 2-3
Channelspecific (DB21, etc.), 2-2
General (DB10), 2-2
Ready signals, 2-3
Speed control loop active, 2-17
Spindle disable, 2-8
Spindle reset, 2-15
U
U(DClink), 2-22
Undervoltage threshold, 2-22
V
Variable signaling function, 2-22
W
WCS, 2-6
Workpiece coordinate system, 2-6
To Next Page
Loading...
Need help?
General
