EasyManuals Logo

Siemens SINUMERIK ONE MCP 2400.4c Function Manual

Siemens SINUMERIK ONE MCP 2400.4c
2050 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1606 background imageLoading...
Page #1606 background image
Brief Description
1.1 Brief description
Feeds (V1)
1-2 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Axis assignment for feedrates
Feedrates can be assigned variably to axes according to technological requirements.
The following assignments are supported:
Separate feedrates for working plane and infeed axis
Variable axis assignment for path feedrate
Feedrate for positioning axes
Feedrate control
The programmed feedrate can be modified for adaptation to changes in technological
conditions during machining or for test purposes.
Via the machine control panel
Via the operator panel
Via the PLC
Via a program command
Feedrate interpolation
To permit flexible definition of the feedrate characteristic, the feedrate programming
according to DIN 66205 has been extended by linear and cubic characteristics.
The cubic profiles can be programmed directly or as interpolating spline.
You can program the following feedrate profiles:
FNORM
Behavior as per DIN 66025 (default setting).
An F value programmed in the block is applied over the entire path of the block, and is
subsequently regarded as a fixed modal value.
FLIN
An F value programmed in the block is positioned from the current value at the start of the
block to the end of the block linearly across the path distance and applies as a modal
value thereafter.
FCUB
The F values programmed non-modally (relative to the end of the block) are connected by
a spline. The spline starts and ends at a tangent to the previous or subsequent define
feedrate. If the F address is missing in a block, the last F value programmed is used
instead.
FPO
The F address [syntax: F=FPO (...,...,...)] designates the feedrate response over a
polynomial from the current value to the end of the block in which it has been
programmed. The end value then applies as a modal value.

Table of Contents

Other manuals for Siemens SINUMERIK ONE MCP 2400.4c

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK ONE MCP 2400.4c and is the answer not in the manual?

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK ONE MCP 2400.4c
CategoryControl Systems
LanguageEnglish

Related product manuals